jjncj.com

A couple more sub-projects on which major progress was made today.

The first had to do with the flow of electricity. The existing electrical system in the house consisted of two side-by-side Pushmatic boxes. For those who've never seen a Pushmatic box, it's exactly what it sounds like. The breakers are really large push-on-push-off switches, as shown to the right. Ancient. You can't buy boxes like that any more, even though the breakers are pretty easy to find. In fact, I've replaced a couple of them that have gone bad. At any rate, one of those boxes fed the lights and outlets in the house, and the other box fed the garage sub panel and the (out of service) electric baseboard heaters. Each box was fed by a 100AMP main from the service entrance. So, it was time to replace them.

We now have installed a brand new, shiny, Square D 200 AMP breaker box right inside our rear entry. All this was accomplished thanks to our new friend Joe Delskie. His wife posted on a local sale/trade list saying he was looking for NEC (National Electrical Code) and IBEW (Internation Brotherhood of Electrical Workers) books. I wrote, asking if he could do some work for us. He could. He does great work, and knows his stuff. If you have any electrical, HRV, other wiring (network, etc), tiling, or general carpentry jobs that need doing, he is looking for work while he does his IBEW classes. Drop me a line and I'll forward your information.

The other project today consisted of putting part of the sewer lines back together. A large section had to be replaced for a couple reasons. One was the discovery of a couple of leaks on the existing sewer pipe, as evidenced by the copper rust around a couple joints (one of those being the toilet run). The other was a puncture from a screw used by a previous owner to hang a bathroom cabinet. Yes, the screw went into the sheetrock of the wet wall, and into the copper pipe behind that.

So, we ended up removing the DWV (drain/waste/vent, refers to the drain and vent system) pipes running to the upstairs toilet, tub, and bathroom sink, as well as a large section of the main three inch DWV pipe. We worked on getting it back in a little last week, but this week Robb and Izzy measured, cut, and fit most of the main DWV pipe, as well as the runs for the toilet and tub. We now have all the pieces ready for gluing. The new runs are actually simpler than the old runs thanks to Robb's creativity and skill with connecting the pieces at various angles. Don't worry, everything still slopes in the right direction. The only thing that made it a little difficult at times was having to cut out the notches in the floors and 2x8s a little more due to the fact that 1.5 inch inside diameter ABS plastic is a bit bigger around than 1.5 inch inside diameter copper.

It was a very productive day. Felt good to see what was accomplished.

Update: Robb informs me that it was in fact Izzy that came up with the idea to use a 22.5 degree joint to match up the tub run to the oddly-angled run for the toilet. Gotta give credit where credit is due!